Carbon Smoke HK MP5 9mm 30rd mag
Carbon Smoke HK MP5 9mm 30rd mag
 
Price: $24.25
This item can not be shipped to the following states:
CA, CO, CT, DC, IL, MA, MD, NJ, NY, RI, VT, and WA.


Product Code: SMK-HKMP5-30
Qty:

PRODUCT DETAILS
 

NEW CARBON SMOKE Mag Features

  • Fits the H&K MP5, MP5K, HK94, SP89, SP5K
  • Works with ETSCAM-RIFLE speed loader
  • Extremely reliable feeding - Even with hollow points
  • Far lighter than steel magazines
  • Fits standard MP5 mag pouches and couplers
  • Standard 30 round capacity
  • Compatible with all MP5 style 9mm firearms such as: Zenith, MKE, Omega, POF, HK Contract MP5 9mm Variants, MP5 style SW5, BW5, CA94, D54, V94, clones or other custom builds
  • Lifetime Warranty

ADVANCED POLYMER BENEFITS

  • Extreme Impact Resistance—won't crack or break when dropped
  • Very resistant to harsh chemicals
  • Superior heat, cold and UV resistance—won’t become brittle over time even when exposed to harsh environments or extreme cold
  • Translucent body—allowing you to see your ammo count and type
  • Creep resistant—the feed lips and body won't spread when being stored long term even when fully loaded
Intellectual Property

Average Rating: Average Rating: 4 of 5 4 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
 
4 of 5 ETS + MKE = Winning Combo April 16, 2023
Reviewer: Adam T from Sparks NV  
With 30 rd steel MP5 mags ranging from $50 to $75, it was a no brainier to give these ETS ones a shot. Online reviews were mixed, some raving about them and others not so much. So it appears that your mileage may vary. My experience was a combination of a mixed start but good feeding during use.

The fit into the mag well, is tight, very tight. No MP5 mags are drop free to begin with but if one doesn't give these ETS ones a swift palm up smack until you feel that latch click, then it won't be completed in. When removing, it took a tug to back come out.

It was easy to see interference making the ETS mags stick, just look for where the drag scratches were happening since the body is polymer. Then with a flat file, I took a little bit off both the front and rear bumps until the fit was snug not tight.

I figure after a few dozen uses, these mags will scratch, err break in.

Was this review helpful to you?